You may worry about getting a ticket if your brakes are not adjusted correctly, but the result could be far worse than just getting a ticket. Solve the problem by weekly making 6 full pressure applications once a week or to make the adjuster turn over and visually check the stroke before leaving the yard.Ī large number of trucks are taken out of service due to brake defects and many of those are due to issues with adjustment.If you are a good driver who manages speed, keeps a safe distance and coast to traffic lights you likely never make an application more than 15 or 20 psi, the brakes wear naturally and the auto slacks don’t compensate.The issue is likely an improper installation, faulty or worn components in the brake system.Adjusting it won’t really fix the problem, manually adjusting at this point will only temporarily fix the problem.If a brake is over-stroking with an automatic adjuster there is a problem with the brake or adjuster.When they go out of adjustment something else is usually happening.Normally don’t require manual readjustment.Automatic slack adjusters do a great job of keeping stroke within limits overall, but a lot are found to be out of adjustment during roadside brake inspections.Improper adjustment often a matter of operator negligence.Under certain conditions, manual slack adjusters could get close to the adjustment limit in a short time.Unfortunately, neither is true, and neither way will measure the brake stroke accurately. At the same time, many believe that if, when using brake stroke indicators, the pointer is inside the markers when the spring brakes are applied than the adjustment is good. Some say if the slack adjuster is at no more than a 90-degree angle to the push rod when the spring brakes are applied, the adjustment is good. The problem is, how do you know that two brakes are adjusted well below the limit and three are over-stroking by an eighth of an inch? You cannot tell, but an inspector can. According to some a 2-psi per axle drop in system pressure, or 10-psi on a 5-axle unit, is acceptable. You can release the spring brakes and build the system pressure to 100 psi, make a full pressure application and note the pressure drop. On disc brakes, it is between the pushrod and the power screw.On drum brakes, it’s between the pushrod and the S-cam.It is located on the axle housing on the air canister near the wheel. On an air-brake system, the slack adjuster is what is used to adjust the brakes.You cannot go by the mileage interval, like an oil change, you have to make the adjustment when it’s required. But since there are no such things as normal truck brakes, slack adjusters are designed to be adjusted. highway environment a manual slack adjuster would probably need adjustment approximately every 10,000 miles. It adjusts and takes up the slack in the stroke as the friction surfaces wear away. While there are some short-cut methods to determine brake adjustment but they will not be accurate enough to pass a DOT inspection. This means marking and measuring the brake stroke which is part of the trip inspection. When you sign the trip inspection form, you need to check the brakes to make sure they are in adjustment. However, all brake systems, whether manual or automatic slack adjusters, should receive regular maintenance checkups. Vehicles made after 1994 have automatic slack adjusters that adjust themselves during full brake applications and should only require manual adjustments during installation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |